Two hardcoded constants decided how far a train could drift before it was put
back, and there was no way to change them short of a rebuild. They are settings
now:
multiplayer.sync.running 1.5 // margin while the train is rolling
multiplayer.sync.stop 0.2 // one precise correction once it stands
The split is what the two numbers are for. A moving train is left to its own
physics unless it is well out, because nudging it several times a second is
worse than the error; a standing one is worth getting right to the centimetre,
and it is done once and then left alone until it moves again - a consist that
has had its correction is marked settled, and clears that mark the moment it
rolls. Both travel in SERVER_HELLO: whatever a player has in their own ini, a
session runs to the host's margins, which is the only way the peers agree on
what "out of place" means.
And the trainsets. Every peer loads its own copy of the scenery - that is the
only reason joining takes seconds instead of minutes - but the copy on disk is
not the session: the host may have shunted a set apart, put one together, or be
running a scenery whose consists were edited since. So the composition travels
in a full snapshot, ahead of the positions: which coupler of which vehicle is
joined to which coupler of which other, and with what hoses and cables. A
joining peer breaks what should not be coupled, makes what should, and only
then gets told where everything is - so the per-consist repositioning works on
the session's trains rather than on the ones its own scenery file described.
The vehicles themselves do not travel, and cannot: a peer missing one gets a
line in the log saying so, not a model over the wire.
Uncoupling has to be forced here. TDynamicObject::Dettach() leaves the
mechanical coupler alone unless the buffers are pressed together, which is
right for a player pulling a lever and wrong for putting a peer's world in
order.
Protocol version 5, snapshot version 6.
Adds the WITH_HARDWARE_PROTOCOL_V2 build option and the eu07.ini entries
which configure it: uart2 declares a serial link and may be repeated for
several controllers, the remaining uart2* entries tune frame size,
heartbeat, rate limits and logging. UART v1 is untouched and both may be
active at the same time on different ports.
The driver mode starts the manager when at least one link is configured
and pumps it from the input polling loop, and the debug panel gains a
Hardware Protocol v2 section reporting link and session condition,
packet rates, round trip time, protocol and transport error counters and
whatever diagnostics the device itself reports, with switches for
protocol and frame logging.
